Network switch and App setup guide

Public Channel / Installation Guides

Although the steps below are specific to Cisco PoE Switches (running IOS) with EventBoard from TEEM installed on the tablets. Similar steps can be taken to setup other switches and mobile App.

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

2. KRONOS SETUP G UIDE 555 - 0015 Rev 1 LIGHTED AND WIRED ETHERNET ENCLOSURES NETWORK SWIT CH AND APP SETUP Page 2 of 2 Once selected it should display a valid IP address for the iPad. 3. [Lighted Enclosure Only] To confirm the enclosure is working properly, make sure the tablet is at full volume (on iPads the volume slider can be accessed b y swiping up from the bottom of the screen), then go to the following address and play the test video: magtarget.com/test 4. [Lighted Enclosure Only] If the light color match the screen then the enclosure is functio ning properly. 5. Install EventBoard on the tablets. 6. [Lighted Enclosure Only] Login to the TEEM dashboard to register the tablets and set the light Frequencies to: Available Frequency: 1500 Occupied Frequency: 370 Check - In Frequency: 670 7. [Lighted Enclosure On ly] Go back to the tablets to confirm the light color match the status of the rooms.

1. KRONOS SETUP G UIDE 555 - 0015 Rev 1 LIGHTED AND WIRED ETHERNET ENCLOSURES NETWORK SWIT CH AND APP SETUP Page 1 of 2 Although the steps below are specific to Cisco PoE Switches (running IOS) with EventBoard from TEEM installed on the tablets. Similar steps can be taken to setup other switches and mobile App. 1. Enter these commands to ensure the switch is set to send enough power to the units, while not locking too much power away from the remaining ports: enable Enter the switch password if requ ested (the password won't show as you type). Default password for Cisco switches is: cisco conf t int Fa4/0/3 Enter the specific port instead of the Fa4/0/3 example shown here power inline static max 25000 The 25000 milliWatts shown here should be sufficie nt to power lighted enclosures in most environments. Additional power may be needed for enclosures far away from the switch. Slim enclosures (not equipped with lights) can work within the original PoE 15 Watts standard and so this "power inline static max" command can be skipped spanning - tree portfast This greatly speeds up the connection on units equipped with the wired Ethernet option exit exit wr mem The snapshot below is how the commands appear when entered via CLI: Enabling LLDP and CDP is also recommended. 2. [Wired - Ethernet Units Only] on iPads go to Settings and co nfirm the Ethernet option is showing.

Views

  • 622 Total Views
  • 377 Website Views
  • 245 Embeded Views

Actions

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Embeds 2

  • 17 support.magtarget.com
  • 9 magtarget.odoo.com